10,000 Watt 440 Amp Charge Controller 12 Volt for Wind Turbines & Solar Panels

Description

Free USPS Priority shipping to the US &
Puerto Rico
You are buying one
12 VOLT 440 AMP  DIVERSION/DISCONNECT CHARGE CONTROLLER
WITH BUILT IN DIGITAL DISPLAY AND INTELLIGENT DUAL PROCESSOR CONTROLLER
Long 5 foot battery sense leads finished with ring terminals!
Provide your own back plate or base for this controller and save money!
Mount on wood or sheet metal (screws not provided).
Works with hybrid systems: connect wind turbines and solar panels at the same time
IT CAN DISCONNECT THE INCOMING POWER
OR DIVERT IT TO A DUMP LOAD
Charge Controller Features:
Connect multiple turbines and solar panels
up to 440 amps worth at the same time!
Max continuous solar amperage in disconnect mode is 100 amps.
Max solar amperage in divert mode is  440 amps. This is a huge hybrid wind and solar charge controller.
Use for wind or solar or both at the same time!
Also use for hydroelectric or solar or both.
User changeable settings
-- Several controllers on the market only let you set the dump level!
Multiple user changeable settings, and trip points for many various system requirements and applications
:You can change the dump point voltage level, end of dump voltage level, length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes)  The controller will also monitor the diversion/disconnect activity and increase it's duration several times when your batteries are full. This feature is also adjustable.
Dual (2) Microprocessor controlled
-- Very stable and very accurate
Isolated Electronics Protection
- Almost impossible to accidentally connect wind or solar directly to the circuit board.
High amp rating
- Can be operated at 100% duty cycle conducting surge loads up to 440 amps or 10,000 watts. Please note that the normally closed contacts can handle 100 amps continuous duty.
Battery Status LED
- Lets you know your battery's actual voltage!
Green LED on board lets you know it's in dump mode
Plug & Play
-
Long leads & ring terminals for easy termination
to your 12 volt  battery bank.
Can divert the charging source from the batteries to the load, or dump both the batteries along with the charging source.
Reverse polarity protection
Ultra low power consumption
even with the volt meter on (almost negligible). You can even set the volt meter to turn off after in-activity.
On board relay
- Isolates electronics from back voltage spikes from large 440 amp relay. This is important to get the longest life out of the electronics. No one else has this!
Be aware of cheap, less capable knock-offs of our model controller that are too basic to properly charge a battery. They will attempt to only turn ON and OFF for the SAME length of time, every time, when your battery is full. This will constantly boil your battery when it's full or not properly fill it or both.
An improperly charged battery will have a short life and cannot be brought back. This means one to two years instead of 10 years or more life! You don't benefit from returning a product after it ruins your system.
A charge controller must operate a relay whether mechanical or solid state(SSRs). The relay turns the charging from your solar, wind, hydro ON or OFF to your batteries. If you have 100 amps of solar charging being turned ON and OFF to your batteries you NEED to vary the time between the ON/OFF cycles. Our controller has custom programming that cannot be duplicated by the Dime Store sellers and is, of course, user changeable.
Our charge controller will more slowly top-off your battery! It will do this by adjusting itself every time your battery is full by increasing the duration of the next OFF cycle by up to 4 increased OFF times.
For example: 5 seconds to 10, then 10 to 20, then 20 to 40 and will maintain a 40 second OFF time.
You can adjust the starting 5 seconds down to 1 or up to 999.
We even went a step further and programmed in a "sweep time" which is a secondary sensing timer that starts directly following an ON cycle. This tells the controller that it has or has not been too long before battery charging is needed again. The user adjustable sweep time allows the user and controller to have a wide range of charging times on any size battery bank.
We also pre-wire and pre-program ours for you to be able to get up and going without becoming an expert. You're taking a risk with your system if accepting a too-good-to-be-true price or product description. If you're not convinced this is the controller for you, please check our other charge controllers or ask us which one is right for you.
Wind &
Solar Controller
Connect to one of our diversion dump loads to make the system complete
CLICK HERE FOR OUR DIVERT/DUMP LOADS!
We do not mark items as gifts or under report values for customs. For International buyers,
it is strongly recommended to check your own country's tax practices as we do not
pay your taxes, duty or customs fees.
We do not over charge for shipping; it is simply what the shipping calculator comes up with.
Customs fees or taxes are not included in shipping, it is your responsibility to pay them.
UPS orders shipped signature required at our discretion!! Contact us right away if you need to make other arrangements!
Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better.